EN
8
BEFORE USING THE APPLIANCE
Installing and operating your fridge
Before starting to use your fridge, you should pay attention to
the following points:
• Operating voltage for your fridge is 220-240 V at 50Hz.
• Mains cord of your fridge has a grounded plug. This plug
should be used with a grounded receptacle that has a
16 ampere fuse minimum. If you don’t have a receptacle
conrming with this, please have it done by a qualied
electrician.
• We do not take the responsibility of the damages that
occur due to ungrounded usage.
• Place your fridge in a place that it would not be exposed
to direct sunlight.
• Your appliance should be at least 50 cm away from stoves,
Gas ovens and heater cores, and should be at least 5 cm
away from electrical ovens.
• Your fridge should never be used outdoors or left under
the rain.
• When your fridge is placed next to a deep freezer, there
should be at least 2 cm between them to prevent humidity
on the outer surface.
• Do not place anything on your fridge, and install your fridge
in a suitable place so that at least 15 cm is available on the
upper side.
• The adjustable front legs should stabilized in an appropriate
height to allow your fridge operate in a stable and proper
way. You can adjust the legs by turning them clockwise
(or in the opposite direction). This should be done before
placing food in the fridge.
• Before using your fridge, wipe all parts with warm water
added with a tea spoonful of sodium bicarbonate, and
then rinse with clean water and dry. Place all parts after
cleaning.
• Install the distance adjustment plastic (the part with black
vanes at the rear) by turning it 90° as shown in the gure
to prevent the condenser from touching the wall.
• Refrigerator should be placed against a wall with a free
distance not exceeding 75 mm.
To Next Page
Loading...
