17
ERROR CODES
Codes
Meanings
Possible Causes
Longer inlet time.
E1
Faucets is not opened, or water intake is
restricted, or water pressure is too low.
WARNING
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak, the water
should be removed before restarting the dishwasher.
If there is an error code that cannot be solved, please request professional
assistance.
Overflow. Some element of dishwasher leaks.
E4
Not reaching required
temperature.
Malfunction of heating element.
E3
Ed
Open circuit or break wiring for the
communication.
Failure of communication
between main
with display .
circuit board
circuit board
If there is a malfunction the dishwasher will display an error code. The following table
shows possible error codes and their causes.
WARNING
USAGE COUNTER
When the power cord is connected, but the dishwasher is not turned on, press and hold
the Delay button for 5 seconds, the dishwasher display will show the usage count.
Example:
632:Show “000” for two seconds, then show “632” for two seconds, at last it will be off.
9080:Show “009” for two seconds, then show “080” for two seconds, at last it will be off.
for 5 Sec.
2 Sec.
for 632
2 Sec.
for 9080
+ +
To Next Page
Loading...
