Corbin Russwin Assa Abloy ML2000 Series User Manual

FM521 11/21
Copyright © 2019, 2020, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information
go to www.P65warnings.ca.gov.
Attention Installer: Improper
installation may result in damage
to the product and void the
factory warranty.
WARNING
Installation Instructions
ML2000 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators

Corbin Russwin Assa Abloy ML2000 Series Specifications

General

Lock Type	Mortise Lock
Series	ML2000
Function	Entry, Classroom, Storeroom
Material	Steel, Brass, Bronze
Finish Options	US4, US10B, US26
Backset	2-3/4"
Door Thickness	1-3/4" to 2-1/4"
Handing	Reversible
Certification	ANSI/BHMA A156.13 Grade 1
Security	High Security

Summary

Tools Required

Indicator Variants

Mortise Lock Handing

Rehanding Indicator

Installation Process

Prepare Door

Steps for preparing the door for lock installation, including hole sizing and template use.

Install Strike and Lock

Procedure to install the strike and the mortise lock body into the prepared door.

Install Outside Trim (Standard Levers/Knobs)

Attaching outside trim components for standard levers or knobs to the lock assembly.

Install Inside Trim (Standard Levers/Knobs)

Installing inside trim components, aligning escutcheons and securing with through-bolt screws.

Install Levers (Standard Levers/Knobs)

Details on installing levers or knobs onto the lock mechanism, ensuring proper alignment and securing.

Attach Levers to Escutcheons (Muséo® Levers)

Instructions for attaching Muséo® levers to escutcheons, focusing on spindle orientation.

Install Outside Trim (Muséo® Levers)

Procedure for installing outside trim for Muséo® levers, aligning posts and sliding assembly through the lock body.

Install Inside Trim (Muséo® Levers)

Steps to install inside trim for Muséo® levers, aligning escutcheon and securing with through-bolt screws.

Install Cylinder

Instructions for inserting and securing the cylinder, ensuring correct orientation and operation.

Install Outside Front

Steps to attach the outside front component, tightening lock screws and securing with flat head screws.

Perform Functional Check

Guidance on testing lock functionality, including key operation, latch retraction, and deadbolt engagement.

Indicator Parts