To Next PageTo Next PageWhat to do if my Cordivari Bollyterm HP heat pump does not switch on?
If your Cordivari Water Heater's heat pump isn't turning on, first ensure there is electricity. Check that the main circuit switch is not open, the plug is properly inserted into the outlet, and the outlet's safety fuse is intact. Verify the power supply and connections.
Why does my Cordivari Water Heater system produce vibrations and unusual noises?
If your Cordivari Water Heater system is vibrating and making unusual noises, it might be due to vibrating covering shells, air channels, or hydraulic pipes. Inspect the unit for any loose covering shells and check the air channels and hydraulic pipes.
What to do if the compressor and/or fan do not start in my Cordivari Bollyterm HP?
If the compressor and/or fan in your Cordivari Water Heater aren't starting, it could be because the set safety times haven't passed yet, the system is full, or there's a loose electrical connection. Verify the set safety times, check if the system is full (indicated by a bright [Hot water] icon), and inspect the electrical connections.
Why does my Cordivari Bollyterm HP Water Heater heat pump keep running without stopping?
If the heat pump in your Cordivari Water Heater is constantly running, it may be due to an excessive heat load or incorrect set point and/or differential settings. Try reducing the heat load or adjusting the set point and/or differential settings.
How to resolve repeated starting and stopping of the heat pump in my Cordivari Water Heater?
If the heat pump in your Cordivari Water Heater is repeatedly starting and stopping, the set point and/or differential settings may be incorrect. Adjust the set point and/or differential settings.
General| Category | Water Heater |
|---|---|
| Brand | Cordivari |
| Model | Bollyterm HP |
| Type | Heat Pump Water Heater |
| Refrigerant | R134a |
| Tank Material | Stainless Steel |
| Power | 1.5 kW |
| Voltage | 230 V |
| Material | Stainless Steel |
| Insulation | Polyurethane |
| Capacity | 200 L |
Explains manual symbols and lists key reminders for safe operation.
Overview of the BOLLYTERM® HP unit and its basic operational principle.
Details the physical components and build of the unit.
Instructions for safe movement and storage of the unit.
Lists relevant European directives and standards for compliance.
Specifies the tank category based on regulations.
Information on product labels and identification data.
Explains the thermodynamic principle of heat pump heating.
Defines key terms and critical safety rules for installation personnel.
Site selection, preliminary checks, and location requirements.
Instructions for water system, condensation, and tank drain connections.
Details on the electric heater flange and safety thermostat.
Guidelines for installing air intake and exhaust ducting.
Safety and procedural instructions for electrical hook-up.
Explanation of the main control board inputs and outputs.
Introduction to the unit's control system and user interface.
Overview of the control panel, buttons, and display icons.
How to view and interpret parameters and messages on the display.
Critical checks before powering on the unit.
Step-by-step guide for initial unit operation.
Instructions for setting the unit's internal clock.
How the unit manages heating sources and temperature control.
Explains Stand-by, Run, Electric Heater, Defrost, etc.
Comprehensive list and description of adjustable parameters.
Visual guide for navigating and adjusting parameters.
Detailed list of alarms and recommended corrective actions.
Safety precautions and annual inspection points.
Guide to resolving typical heat pump operational problems.
