HANDGRIPS
POWER/SPEED
SWITCH
GROUNDING
PLUG
VINYL MASSAGER PAD
Jeanie Rub Variable Speed Massager
Model: 3401
Universal motor
120 VAC / 60 Hz / 2.0 Amperes
Operating Range: 1100 - 4600 rpm
Rotary power switch/speed control
6.05 lbs. (2.7 kg)
All Jeanie Rub Massagers are built to ANSI
Standards and certied by the Canadian
Standards Association. The CSA mark on
your massager ensures that it has been
evaluated to meet or exceed the
ANSI/UL/CSA consumer safety standards
for use in the United States and Canada.
YOUR JEANIE RUB MASSAGER
INDICATIONS FOR USE
The Jeanie Rub Massager delivers invigorating 1100 - 4600 rpm orbital massaging action. Use the Jeanie Rub massager on
any part of the body, head to toe.
Connecting this product to an improperly grounded electric receptacle may result in re or electric shock. Using this
product near water may result in electric shock. If you suspect massager may have come into contact with water, do not use.
Grounding Instructions:
This product is equipped with a grounding plug which must be connected to a properly installed and grounded 120 volt
receptacle. Do not modify the plug provided. Check with a qualied electrician or serviceman if you are in doubt as to
whether the receptacle is grounded.
OPERATING INSTRUCTIONS
1. Plug power cord into 120 vac wall receptacle.
2. Firmly grasp massager handgrips with both hands from above with thumbs toward center of unit.
3. Turn rotary power switch clockwise to begin operation.
4. Turn rotary power switch to adjust speed to a medium operating mode.
5. Place massager in contact with body.
• Allow massager to do the work. It is not necessary to press down on massager to achieve results.
• Find a speed that is most comfortable to the individual. Use lower speeds to ensure a more soothing
massage. Use higher speeds to deliver a more invigorating massage.
• Therapeutic benets can be achieved in as little as 5-10 minutes per area, but may vary by individual.
• For direct contact on skin, Core Products recommends using any of the Jeanie Rub covers to protect the
vinyl pad of your massager. Using covers also allows the use of oils, lotions or creams. Using oils, lotions or
creams without a cover may prematurely crack or erode the vinyl pad.
6. To stop operation, turn power/speed switch counter-clockwise.
GENERAL WARNINGS AND PRECAUTIONSDANGER:
To reduce the risk of electrical shock.
Note: Your Jeanie Rub Massager operates at speeds upto 4600 RPMs. If you are accustomed to older Jeanie Rub models, this faster
speed may seem excessive. Please be assured this is completely normal as each unit is individually tested to meet our standards.
To Next Page
Need help?
General