Need help?Do you have a question about the Core RC UAC-50 and is the answer not in the manual?
General| Brand | Core RC |
|---|---|
| Model | UAC-50 |
| Category | Battery Charger |
| Language | English |
Provides essential warnings for safe operation, including unattended charging, environmental conditions, and proper surface placement.
Emphasizes checking battery specifications to match charger requirements and avoid damage or explosion from incorrect setup.
Instructs to connect the charge cable to the charger first, then the battery, and reverse for disconnection to prevent short circuits.
Warns against connecting multiple battery packs or charging/discharging incompatible battery types.
Lists battery types that should not be charged or discharged, such as mixed cell types, faulty, or device-integrated batteries.
Recommends verifying program selection, current setup, and battery voltage (especially for parallel/series LiPo packs).
Stresses the importance of secure connections to prevent intermittent contacts.
Highlights the need for special attention to Lithium battery connections and warns against arbitrary disassembly.
Explains lithium battery wiring in parallel and series, warning of voltage imbalance risks and recommending series charging.
Guides setting the correct nominal voltage for LiFe, Lilo, or LiPo batteries to prevent explosion.
Explains setting a time term for the processor to verify lithium battery cell count, preventing errors from deep discharge.
Details trigger voltage for automatic NiMH/NiCd termination, warning of overcharging or premature termination risks.
Explains the safety timer to prevent overcharging and provides a calculation method for NiCd/NiMH batteries.
Details the maximum capacity protection function that stops charging when a set capacity is reached.
Monitors input battery voltage and forcibly ends the program if it drops below a user-set value.
Describes the program for Lithium batteries (3.3-3.7V/cell), covering constant voltage/current methods and precise final voltage settings.
Details the process of setting battery type, current, and voltage for charging Lithium batteries.
Explains how the charger displays detected vs. set cell counts and the procedure for verifying them.
Describes charging Li-Po/lon/Fe batteries without a balance lead, using manual current and voltage settings.
Explains the balance charging mode for Lithium batteries requiring a balance lead for individual cell equalization.
Details the balance mode process, where the charger monitors and controls current to individual cells for voltage equalization.
Guides setting current and voltage for fast charging Lithium batteries, including cell count verification.
Explains the fast charge mode, where current reduces towards the end, shortening time but slightly reducing capacity.
Allows setting current and voltage to bring batteries to a 'Storage' state for long-term preservation.
To Next Page