GENERAL INFORMATIO
Universal Wall Remot
SN:052-01S 052-01SW
Model:RC-T26&RC-26SR
e
N
This remote controller is designed for 3-speed ceiling fan to separately control your ceiling fan speed and light
brightness.
There are eight buttons to control the speed of the fan and off, and timing.
The light dimmer button will control the light brightness dimmer and off (dimmable LED or incandescent only).
The blue indicator on the transmitter will light when one of the eight buttons is pressed.
INSTRUCTION OF INSTALLATION AND OPERATION
Read instructions completely before installing the remote.
• Do not install in damp locations. For indoor use only
WARNING: If the color of the household supply wires is different than what is referred to in the instructions below,
a professional electrician should determine proper wiring.
CAUTION:
.
• Do not use with fans that have integrated remote controls.
• Do not use with hugger-style fans.
• Be sure the outlet box is properly grounded or that a green or bare (ground) wire is present.
• This unit is intended to control a ceiling fan with electrical source of AC 110/120V, 60Hz.
• To reduce the risk of fire or electric shock, do NOT use a full-range dimmer switch to control the fan speed.
ASSEMBLY INSTRUCTIONS
1. Use existing pull chains on the desired fan to set fan speed to HIGH and to turn the light ON.
2. Turn off circuit breakers and wall switch to the fan. DANGER: Failure to disconnect power supply prior to
installation may result in serious injury or death.
3. Lower the canopy of the previously assembled fan and insert receiver into the mounting bracket with antenna end
first and the flat side facing the ceiling. Note: If installing this product with a new fan, insert the receiver in the
mounting bracket before wiring the fan; wire the fan according to these instructions, then continue fan assembly as
directed in the fan’s instruction manual.
4. CONNECT TO
Red receiver wire(AC IN L).......... Red supply wire
White receiver wire(AC IN N)..........White supply wire
White receiver wire(TO MOTOR N)..........White com(FAN/LIGHT N) wire
Black receiver wire(TO MOTOR L)..........Black fan wire
Blue receiver wire(TO LIGHT L)..........Blue light wire
1
http://www.ceilingfanremote.com
To Next Page
Need help?
General
