Corioliss C1 - User Maintenance Instructions; Contact Details; Operation

6 7
operating and user maintenance instructions operating and user maintenance instructions
EN EN
Operating instructions
Plug your Corioliss styler into the power supply.
Shift the ON/OFF button to the ON position. At this moment the red and green lights will
be on.
Adjust the temperatura manually with the control Wheel. The Green light dissapears when
it reaches the required temperature. The red light will be still on because it indicates that
the styler is On.
Shift the ON/OFF button to the OFF position to unplug it. Once is OFF, let it cool down in
a safety place.
Unplug your Corioliss styler from the mains power supply.
Always allow the Corioliss styler to cool before attempting to clean it.
Never immerse the appliance in water.
Wipe the outside and the plates with a damp cloth. Do not use sharp or abrasive detergents
or corrosive products.
Do not use hair products that could leave residues on the plates.
In the unlikely event that your Corioliss product does not operate correctly, check that the
Corioliss product and mains power supply are switched on, and that power is available.
Your Corioliss styler is a product designed to work at a high level. If while using it the device
has gone through strong variations in the electrical power supply, can go into security mode
to prevent possible damage.
Therefore, in the unlikely event that your Corioliss product does not operate correctly,
check that the Corioliss product and mains power supply are switched on and that power is
available. If the product stops working, follow these steps:
Turn off the styler.
Unplug the styler from the main power supply.
Wait for a few seconds and plug the device again into the main power supply.
Turn on the styler.
In the case of any repeated faults or problems, please contact Corioliss Service Center.
Always allow the Corioliss styler to cool down before storing away.
When the Corioliss styler has cooled down, fold the power cord in the same way as it was
first delivered in its packaging. Do not wrap the supply cord around the Corioliss styler as
this can strain the cord and cause premature supply cord failure.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
1.
2.
CLEANING
STORAGE
Operation
User maintenance instructions
Failure to operate
Corioliss Europe S.L.
Polígono Industrial El Rubial Calle 1 Pacela 10
03400 Villena – Alicante
Spain
+34 96 581 78 28
info@corioliss.es
www.corioliss.com
Contact details
Made in RPC
1.
2.
3.
4.
This tool is not only attractive to you but also to your children. Please ensure
you always store it out of reach of children particularly during use, especially
when cooling.
Plates
Power ON/OFF key
Temperature control wheel
Power cord
1.
2.
3.
4.