Please note the following points before installation:
- Installation should only be performed by experienced technicians
under the consideration of DIN1988 and VOB.
- Before starting the installation, please stop the water supply
(ideally close the main valve at the water meter).
- Please make sure that during assembly all seals t properly
(Always check - water damage possible)
- The tting is suitable for use in private households and only in rooms with a temperature above 0 °C.
If there are a risk of frost, the water supply should be interrupted and the valve must be completely
emptied.
- Always before the rst use and when a tting has not been used for a prolonged period, you should
let rinse out a larger amount of water (water stagnation) before drinking water is taken!
- Important MOUNTING Note:
The exible connection hoses may only be hand screwed into the tting. Do not use under any circum-
stances tools like pliers or wrenches.
Instruction-manual:
Operating conditions:
Care instructions:
Hot water temperature max. 80 ° Celsius
Test pressure max. 16 bar
Operating pressure max. 10 bar
Holding pressure for shower conversion min. 0.8 bar
(To keep noise level DIN 4109 pressure reducers have to be installed
in the main line for pressures of more than 6 bar).
Reserve technical changes.
Sanitary taps require special care. Please note the following information:
Chrome surfaces:
are sensitive for chemicals, acid-containing cleaning supplies and all kinds of abrasives.
Occasionally clean with soapy water, using a soft cloth. Remove lime deposits with household vinegar.
Colored surfaces:
The surfaces of these taps are sealed with a special baking varnish. Do not clean with abrasive, corro-
sive or cleaners containing alcohol.
Clean only with cold water and a soft cloth or leather.
Surface damages can be expected especially in colored ttings for inobservance of care instructions.
Warranty claims will not be asserted.
To Next Page
Loading...
