Why is Cornelius Accessories beverage foaming for all brands?
Beverages may foam for all brands if the storage temperature is not correct, the CO feed pressure for the soda circuit is too high on the relevant pressure-reducing valve, or the syrup has been stored for too long and has had CO added. In the case of the syrup issue, connect a new syrup container.
What to do if Cornelius Energize 2 HC Accessories only dispenses soda?
If only soda is being dispensed, it could be due to several reasons. The syrup container might be empty, so connect a new one. Ensure the connections on the syrup container are properly connected. Check if the CO feed pressure for the syrup circuit is set incorrectly on the relevant pressure-reducing valve and adjust it. Also, verify that the syrup tube is connected to the syrup container. Open the shut-off valve and pressure-reducing valve for the fresh water supply. Check the water pressure on the pressure-reducing valve and adjust it if necessary.
What to do if Cornelius Energize 2 HC Accessories beverage is too warm and the compressor is running?
If the beverage is too warm, and the compressor is running, it may be due to excessive beverage dispensing. Ensure not to exceed the maximum dispensing capacity.
What to do if Cornelius Energize 2 HC soda/syrup ratio is incorrect?
If the soda/syrup ratio is incorrect, the CO feed pressure for the syrup circuit may be set incorrectly on the relevant pressure-reducing valve. Adjust the CO feed pressure to the required value.
What to do if Cornelius Accessories beverage is too warm and the compressor is not running?
If the beverage is too warm and the compressor isn't running, ensure the undercounter cooler is switched on and start up the undercounter cooler. Switch on the compressor.
What to do if Cornelius Accessories only dispenses syrup?
If only syrup is being dispensed, check if the circulation pump and the carbonator pump are switched off. If so, switch on the circulation pump and switch on the carbonator pump.
What to do if Cornelius Energize 2 HC Accessories power/mains (green) + alarm (red) flash alternately?
If the power/mains (green) and alarm (red) lights flash alternately, the carbonator system may be blocked. Briefly stop operation of the undercounter cooler.
What does it mean if Cornelius Energize 2 HC CO alarm is on (orange)?
If the CO alarm is on (orange), it indicates that the CO pressure is less than 0.35 MPa, and the carbonator pump, valves, and solenoid valve have been deactivated. Check the CO supply.
What does it mean when Cornelius Accessories power/mains (green) flashes approx. 4x per second?
If the power/mains (green) light flashes approximately 4 times per second, it indicates an overvoltage greater than 260 V, and consumers are blocked. An automatic reset is performed.
What does it mean when Cornelius Energize 2 HC power/mains (green) flashes approx. 1x per second?
If the power/mains (green) light flashes approximately 1 time per second, it indicates a low voltage less than 190 V, and consumers are blocked. An automatic reset is performed.
General| Brand | Cornelius |
|---|---|
| Model | Energize 2 HC |
| Category | Accessories |
| Language | English |
To Next Page