INTRODUCTION
Thank you for choosing a Cornell Acoustic amplifier.
Your amplifier employs valve technology. It is hand built to MOD standards. Only top
quality components are used so that you can enjoy years of professional use.
Please take time to read this manual, to ensure that you get the best
from your amplifier.
Amplifiers of today try to offer a wide range of tones and sounds resulting in a mass of
controls that can confuse even the most enthusiastic fiddler.
The result of this is that most amplifiers of today sound the same with a noticeable loss of
natural tone that can only be reproduced by simple design and point to point wiring.
Before Operating your amplifier Please Read these Important Safety
Instructions.
Do not operate or use close to or in wet, damp, conditions, keep away from liquid.
Do not operate or use close to any Heat sources such as radiators, power lighting,
Cooking stoves, fires, or any direct source of heat.
Do not cover or block any ventilation openings. These may be on the top or on the back.
This product must be Earthed. It will come with a 3 pin plug or 3 pin outlet connector
It is for your safety that all terminals are used and go directly back to the wall socket.
Speaker Output.
There is a risk of electrical shock from the speaker output terminals.
Never operate the amplifier without the speaker outlet being connect to the correct
speaker impedance.
Servicing.
Refer All servicing to a qualified service person.
Should a problem occur make sure the amplifier is un-plugged and not connecter to a
mains supply then Contact a service person.
We do recommend that you change the valves yourself, should you attempt to change a
valve remember to disconnect the unit from the wall so no mains voltage is present in the
unit. Remember Valves are hot and can burn the skin so always allow 10 to 15 minutes to
them to cool.
WARNING:
TO PREVENT DAMAGE, FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED
PERSONNEL ONLY.
THIS UNIT MUST BE EARTH GROUNDED.
P.1
To Next Page
Loading...