6
When Using for the First Time
Remove all the plastic and cardboard packaging from the thermo pot.
Ensure that the local mains voltage is same as stated on the thermo
pot.
Never use the thermo pot near to the sink, bathtub, shower or any
other places that may contain water.
Remove any protective films or stickers from the thermo pot before
using it for the first time.
Ensure that the power switch is at the “OFF” position.
Important note: We offer the assurance that all PP and silicon
materials used in the construction of the thermo pot are food grade
materials and are not harmful to humans. For any new thermo pot,
however, it is normal that an unpleasant odor may be detected from
the water that has just being boiled. This will gradually disappear
after about 2 to 3 boiling. To assist in eliminating this odor and also to
remove any possible manufacturing dust, please discard the first and
second boiling of water from the thermo pot.
Operating Procedure
1. Open and lift up the lid. Carry the thermo pot by holding the handle to
the water tap to fill it up. Water may also be filled using a kettle or jug.
2. Plug the power cord to the connector inlet of the thermo pot.
3. Connect the power plug to the Mains electrical outlet and switch on.
4. When boiling is completed, the “Keep Warm” light will illuminate.
5. Press the “Dispense” button or manually press the pressure pump to
dispense the water.
6. Press the “Reboil” button to boil the water again when it has been
kept warm for too long.
To Next Page
Loading...