CORONA 3 - Manifolding Capabilities; Oiling the Typewriter; Cleaning the Typewriter

How
to
Use
Corona
This
permits you to take off the spool containing
the
worn
ribbon and replace
it with a
fresh one. Now
attach the
loose end
of the fresh
ribbon
to empty
spool as follows:
1.
Fold
back
end
of
ribbon so that
it will form a
loop
and
grasp between
thumb and
forefinger
of
right
hand
as
illustrated
in
Cut
A.
2.
Holding spool
in left hand, slip loop
of ribbon over
sleeve
of spool.
(See Cut
B.)
-i
f
'<«X
''-$"
stmt* ?sSB*
^St
e
*&£*
:
^ a
•*&
"f^lP I
I
L* 4r*
7
J*!****
3. Squeeze thumb and forefinger together
so
as to
tighten
loop
on
spool,
being very careful
to
have edge
of
ribbon
just
touching
top of spool.
4. Take clip,
removed from empty spool, in left hand
and
snap
on
over ribbon. The whole
secret lies
in
keeping the loop
of
ribbon
so tight on the sleeve of spool that
its
position cannot be
disturbed
by
snapping on the
clip.
The
ribbon
must
now
be
inserted
in
slot of
vibrator.
Note—
In order that the
vibrator may
be raised
to an
accessible
position, set
indicator
for red,
depress
space
bar
and
slip
post
card
or envelope
between space
bar
and bottom of lowest
bank
of
keys.
This
will
hold the
vibrator
up
and will
leave
operator
with
both
hands
free.
(See
illustration.)
10
i