OPERATIONAL MAINTENANCE
WINTERIZING
APPLICABLE TO BOTH HULL AND ENGINE:
Off season storage procedures vary
accordingly with factors such
as
type of storage, climate and length of storage. These
variables preclude recommendation of specific procedures. Instead Correct Craft advises
that you consult your engine owners manual and seek advice from your dealer or the
manager of the storage facility.
One important point should be mentioned, however, and that
is
the proper way to cradle
your boat. Our
"A"
frame trailer was designed for your Correct Craft boat with longitudinal
supports
as
the preferred method of cradling, since they allow for
an
equal distribution
of weight.
If you
dont
have a trailer, then a cradle should be used that takes into account the even
distribution of weight.
If
you have no dealer or marina nearby and must arrange off-season storage yourself,
please feel free to contact your regional warehouse
as
provided
in
section one of this
manual for recommendations for your particular area.
Speedometer maintenance and winterizing are covered under "Controls and Gauges."
If you use a mooring cover,
DO
NOT put
it
on
when the interior of the boat
is
wet
and/or
hot.
It
will
trap moisture that can lead very quickly to mildew. Try to provide some
ventilation if your cover does not have built-in provisions, even if you have to leave a
portion of it unattached.
Even
the natural build-up of moisture can have unhappy
consequences.
Late
in
1985, Correct Craft initiated a change from a water filter manufactured by Vetus
to one produced by Sherwood. The Sherwood filter bowl remains full of water even after
the rest of the raw water system has been drained. To properly winterize your boat,
the filter bowl should be removed and emptied. Be careful to not lose the rubber
O-ring that seals the bowl to the cap. If the water
is
not removed, the bowl could
be
subject to freeze damage and therefore cause overheating problems during the next
season.
090192
4.13
To Next Page
Loading...
