YOUR
BOAT
PUMP/AUTO:
This switch operates the electronic bailer using automatic electric bilge
pump
switCh.
(Correct Craft's walk over models have two electric bilge pump switches.)
If
the bilge takes
in
water beyond a certain pre-set level, the electric sensor will
automatically turn on the pump until the water
is
below that level.
In
order to keep
sloshing water from causing the pump to turn on and off repeatedly, there
is
a time delay
built into the automatic sensor. Water must
be
in
contact with the sensor for 15-20
seconds before the pump
is
actuated. Ukewise, the pump will remain on for 15-20
seconds after water
is
below the sensor
level.
Note, however, that
for
this function
to
be operative, the switch must be in the "on"
position. This will NOT drain significant power from your battery unless the bilge
pump is called upon
to
run frequently because
of
a leak
or
rainwater accumulation.
The automatic system should not be relied upon over
an
extended period
of
time.
We suggest you frequently inspect your boat.
PUMP/MAN:
This switch operates the bilge pump without benefit of any automatic
devices. Simply push it
in
to engage. NOTE:
DO
NOT
run the bilge pump dry for
extended periods of time.
NAV
LTS:
This controls your navigational lights. The law requires that while running,
after sunset and before dawn, the combination side lights (located at the bow) and the
360 degree
all
around-light (located at the stern)
be
operating.
ANCHOR: This switch activates only the
360
degree
all
around light. It
is
called the
"anchor light" and
is
required by law to be shown whenever the boat
is
in
navigable
waterways but not underway, after sunset and before dawn.
ACCESSORIES: If you have additional components installed on your boat, such as a
cigarette lighter, searchlight, compass light, depth flasher and the like, they may
be
controlled by these switches.
NOTE: SUCH ACCESSORIES SHOULD
BE
INSTALLED AND
WIRED
BY
SOMEONE
KNOWLEDGEABLE
IN
MARINE
WIRING.
IGNITION: This switch activates the blower and MUST
ALWAYS
BE
ENGAGED
FOR
AT
LEAST
FOUR
(4)
MINUTES
BEFORE
STARTING
THE ENGINE. THIS PROCEDURE
IS
MENTIONED ELSEWHERE
IN
THIS MANUAL AND MUST
BE
FOLLOWED
FOR
THE
SAFE
OPERATION OF
YOUR
BOAT.
CLOCK: The clock operates ONLY when the ignition push button switch
is
in
the
"ON"
position (pushed in). To reset, simply push
in
the reset knob on the clockface and turn
to the desired time.
12-VOLT RECEPTACLE: A 12-volt receptacle for operating accessories
is
located on
the side of your Nautique dash pod.
G090192
9.3
To Next Page
Loading...
