CORREX UP 2.3-919 User Manual

OOppeerraattiinngg IInnssttrruuccttiioonnss
CORREX
®
UP 2.3-919
8. Use only the original sealing material.
NNoottee::
If the CORREX
®
UP system is installed by way of retrofitting, any
existing holes of former insulated-hole mounted magnesium anodes can be
used.
77..22..22 SSkkeettcchh:: FFiittttiinngg aanndd ccoommmmiissssiioonniinngg
The illustration on the fold-out page (chapter 11.1) of this manual shows an
example of the installation procedure for a CORREX
®
UP system. The illustra-
tion shows the installation in a flange-type cover. The actual situation depends
on tank type, tank size, type of anode and connecting cables used.
NNoottee::
Leave the fold-out page (chapter 11.1) open when installing the system.
The following parts are need for fitting:
1. Titanium anode (
11
)
2. Connecting cables (
33
)
3. Plug-in potentiostat (
22
)
4. 1 seal (Viton) (
44
)
5. 1 Insulation sleeve M8x2 (
55
)
6. 1 Diode board
7. 2 Hex nuts M8 (
77
) and (
99
)
8. 1 Tooth lock washer with tab connector 6.3 x 0.8 mm (
88
)
77..22..22..11 RReettrrooffiittttiinngg kkiitt ffoorr iinnssuullaatteedd--hhoollee mmoouunnttiinngg
IInnssttrruuccttiioonnss ffoorr tthhee iinnssttaallllaattiioonn ooff tthhee ttiittaanniiuumm aannooddee
1. Scope of application
The retrofitting kit permits installing the titanium anode and the required
components in conformity with the requirements for insulated-hole mounting.
2. Illustration
Fig. 4 in the Annex 'Mounting kit for retrofitting' shows the order in which
the individual parts are to be installed.
NNoottee::
Use the illustration as a visual aid for the installation.
3. Installation
The installation is effected in compliance with chapter 7.2.3
77..22..33 IInnssttaallllaattiioonn ooff tthhee CCOORRRREEXX
®®
UUPP ssyysstteemm ffoorr iinnssuullaatteedd--hhoollee mmoouunnttiinngg
1. Empty the storage tank, if necessary.
2. For retrofitting, remove the old protective (Mg) anode, if any.
3. If not yet existing, drill a hole with a diameter of 10.5 mm into the
flange-type cover of the hot-water strorage tank.
35
0425_Bed.anl_UP_Innen_gesamt.qxd 25.05.2006 19:14 Seite 35

CORREX UP 2.3-919 Specifications

General

Brand	CORREX
Model	UP 2.3-919
Category	Water Heater
Language	English