CorroVenta K3 ES HP - Fault Tracing; Technical Data

© Corroventa Ltd.
2017.07
27 (27)
Fault tracing
Fault symptom
Probable cause
Actions
The capacity of the dryer seems
to be low
Low ambient temperature or
low relative air humidity.
The air flow is heavily reduced
because of dirty filter.
If the dehumidifier is used with
a hygrostat, this may be
incorrect or incorrectly set to
too high a relative humidity.
During the time it has been
installed, the machine has
stopped on numerous
occasions because of either too
high or low ambient
temperature.
Check relative air humidity.
Increase the temperature in
the area.
Replace the filter.
Check the external hygrostat
function by raising and
lowering its setpoint and note
that the machine switches off
and on.
Ensure that the temperature is
kept within the machine's
operating range, 9 °C to 38 °C,
and note that the capacity
increases with increasing
temperature.
Technical data
K3 ES HP
Operating range, RH, %
30-100%
Operating temperature range, °C
+9 - +38
Rated output, W
550
Actual output, W
420
Dehumidification, max., litres per 24 hours
30
Dehumidification at 30°C, 80% RH, litres per 24 hours
21
Dehumidification at 20°C, 60% RH, litres per 24 hours
12
Air flow, m
3
/hour
300
Supply voltage, 1 phase, 50Hz, V
230
Safety class
IP X4
Weight, kg
22
Dimensions, length x width x height, mm
430 x 295 x 470
Noise level, dB (A) 3m high speed
52
Noise level, dB (A) 3m low speed
47
Refrigerant
R410A