3 4
ENGLISH
> Turn on your computer and connect the USB wireless receiver to an available USB port.
> Toggle the power / wireless mode switch to “2.4GHz” position to turn on your mouse.
> The multi-purpose LED indicator on your mouse will turn solid white when automatically connected.
> Download CORSAIR iCUE software from www.corsair.com/downloads.
> Run the installer program and follow instructions for installation.
SETTING UP YOUR MOUSE USING 2.4GHz WIRELESS
> Turn on your Bluetooth 4.0 or higher enabled computer and initiate Bluetooth pairing mode on it.
> Hold the DPI CYCLE button and toggle power / wireless mode switch to BT position to turn on your mouse.
> The multi-purpose LED indicator will start blinking blue.
> The multi-purpose LED indicator on your mouse will turn solid blue when connected.
> Turn off the mouse by flipping the power switch to the OFF position.
> Press and hold the Left and Right buttons simultaneously.
> Turn on the device with either wireless mode.
SETTING UP YOUR MOUSE USING BLUETOOTH
®
HOW TO PERFORM A FACTORY RESET
> Various aspects of mouse operation are communicated through the multi-purpose LED indicator located on
top of the mouse.
If power is low or battery life is a priority, please switch to Power Saving Mode for extended battery life.
Please download iCUE for full power management features.
Mode switching without iCUE: To enter Power Saving Mode, turn the power switch to OFF. Press and hold
the scroll wheel button and then slide the power switch to either 2.4GHz or Bluetooth, then release the scroll
wheel button.
Follow the same steps to switch back to Gaming Mode.
MULTI-PURPOSE LED INDICATOR
POWER MANAGEMENT
MULTI-PURPOSE
LED INDICATOR
POWER
STATUS
GAMING MODE BLINKING PURPLE
POWER SAVING MODE BLINKING YELLOW
BAT T E RY
STATUS
BATTERY CRITICAL. NEW BATTERY REPLACEMENT REQUIRED PULSING RED
BATTERY LOW BLINKING RED
BATTERY MEDIUM BLINKING AMBER
BATTERY HIGH BLINKING GREEN
BATTERY FUL L GREEN
WIRELESS
STATUS
2.4GHz WIRELESS MODE – PAIRING BLINKING WHITE
2.4GHz WIRELESS MODE – PAIRED WHITE
2.4GHz WIRELESS MODE – PAIRING FAILED PULSING WHITE
BT WIRELESS MODE – PAIRING BLINKING BLUE
BT WIRELESS MODE – PAIRED BLUE
BT WIRELESS MODE – PAIRING FAILED PULSING BLUE
DPI STAGE
STATUS
STAGE #1 – 800 DPI RED
STAGE #2 – 1500 DPI WHITE
STAGE #3 – 3000 DPI GREEN
Initial LED indication sequence: When powering on the mouse, the LED indicator will flash 12 to 15 seconds to
indicate various statuses in the following order:
Power Status* > Battery Status > Wireless Status > DPI Stage
*Will only show when there is a mode change.
To Next Page