To Next PageTo Next Page
Need help?Do you have a question about the Corsair SF600 and is the answer not in the manual?
Protects PSU by shutting down if DC outputs exceed set levels.
Ensures DC voltage rails stay within safe operating limits.
Shuts down PSU if internal temp reaches a set point due to overload.
Shuts down PSU during short circuits to prevent unit/component damage.
Instructions for removing the old power supply before installing the new one.
Detailed steps for installing the new SF Series power supply into the chassis.
General| Total power | 600 W |
|---|---|
| AC input voltage | 100 - 240 V |
| AC input frequency | 47 - 63 Hz |
| Power protection features | Over power, Over voltage, Overheating, Short circuit, Under voltage |
| Purpose | PC |
| ATX version | 2.4 |
| EPS version | 2.92 |
| Silent mode | Yes |
| Bearing technology | Rifle |
| 80 PLUS certification | 80 PLUS Platinum |
| Supported motherboard form factors | ATX |
| Power supply unit (PSU) form factor | SFX |
| Cables included | AC, DC |
| Cabling type | Fully-Modular |
| SATA power cable length | 450 mm |
| Motherboard power connector | 24-pin ATX |
| Motherboard power cable length | 300 mm |
| PCI Express power cable length | 400 mm |
| Number of SATA power connectors | 4 |
| Peripheral (Molex) power cable length | 330 mm |
| PCI Express power connectors (6+2 pin) | 2 |
| Cooling type | Active |
| Fan diameter | 92 mm |
| Fan location | Top |
| Number of fans | 1 fan(s) |
Weight and Dimensions| Weight | 860 g |
|---|
