6 - installation of the car seat 9 to 18kg (group 1 - approx.
9 months to 4 years old) - part 2
Adjust the child car seat to the most reclined position (a). See step 4.
Remove both shafts by releasing the end from its lock (b) and pulling the shafts out of
the seat (c). Pull the seat forward to gain access to the rear of the seat (d).
Open the lower belt clip by lifting the retaining rod with your finger (f) and pulling the
belt lock back.
Press down on the tab to open the shoulder belt clip (g).
7 - installation of the car seat 9 to 18kg (group 1 - approx.
9 months to 4 years old) - part 3
Install the vehicle seat belt ensuring that the lap belt fits into the clips at the base of the
car seat (a) and the shoulder belt fits into the shoulder belt clip (b) nearest the the
vehicle seat belt buckle.
Fasten the vehicle seat belt (c).
Pull the shoulder belt (d) to remove the slack from the belt.
Press down on the shoulder belt clip (e) and close the tab to lock the shoulder belt in place.
Press down on the lower belt clip (f) until it locks in place. Ensure the retaining rod is
correctly located (g).
8 - installation of the car seat 9 to 18kg (group 1 - approx.
9 months to 4 years old) - part 4
Lift the vehicle seat belt (a) and push the upper shaft back into position (d) and under the
belt.
Push the upper shaft into the clip (c) to lock it in position.
Close the child car seat and push the lower shaft into position (d) and lock it in place (c).
Note: The upper and lower shaft can be fitted from either side of the child car seat.
Important: The vehicle seat belt MUST fit over the upper shaft (e).
9 - seating your child into the car seat harness
Loosen the harness by pushing the adjuster button (a) in as you pull the shoulder straps
(b) forward as much as possible.
Important: Pull the harness UNDER the chest pads. DO NOT pull on the chest pads.
Unfasten the harness buckle by pressing the red button (c) and releasing the clips (d) and
open out the belts (e).
Place your child in the child car seat.
Fit the harness around your child and fasten the harness buckle by joining the clips (f)
and pushing them both into the buckle (g).
Check that the harness is not twisted and pull the harness up (h) to tighten the lap
To Next Page
Loading...
