4.2. ASSEMBLY AND SET
Before
coupling the machine to the 3
not possible the
involuntary and/or accidental raising and lowering of the arms.
The 3-
point hitch of the tractor and of the machine must coincide or must be adapted.
In proximity of arms rods of the back lifter of the tractor, there is the danger of wounding, because of
crushing and cutting points.
Do not use the external controls for the lifting of the machine. During transport position block the lateral
stop of the rods.
4.3.
TRACTOR REQUIREMENTS AND 3
Check the
raising ability and the stability of the tractor through the following formula and if it is
necessary please apply some ballasts on the back.
It
is obligatory to check the raising abilit
in order to avoid the overturning and/or the loss of wheels
UP
coupling the machine to the 3
-
point hitch, positioning the safety devices to the tractor, so that it is
involuntary and/or accidental raising and lowering of the arms.
point hitch of the tractor and of the machine must coincide or must be adapted.
In proximity of arms rods of the back lifter of the tractor, there is the danger of wounding, because of
Do not use the external controls for the lifting of the machine. During transport position block the lateral
TRACTOR REQUIREMENTS AND 3
-POINT HOOK-UP
raising ability and the stability of the tractor through the following formula and if it is
necessary please apply some ballasts on the back.
is obligatory to check the raising abilit
y and the stability of the
before
carrying out the connection with the machine
in order to avoid the overturning and/or the loss of wheels
1
point hitch, positioning the safety devices to the tractor, so that it is
point hitch of the tractor and of the machine must coincide or must be adapted.
In proximity of arms rods of the back lifter of the tractor, there is the danger of wounding, because of
Do not use the external controls for the lifting of the machine. During transport position block the lateral
raising ability and the stability of the tractor through the following formula and if it is
y and the stability of the
carrying out the connection with the machine
)
in order to avoid the overturning and/or the loss of wheels