5
ENGLISH
1 2 3
4 5
Description
1. 1/2″ square drive spindle
2. Gear box
3. Rear housing
4. Power switch
5. Handle
Use
1. The impact wrench comes with 4 sockets (17, 19, 21 and 22 mm). Fit the desired
socket onto the drive spindle before connecting the tool to the wall socket.
2. Push the socket onto the spindle until it locks into place.
3. Push the socket over the nut/bolt to be tightened or undone. Hold the impact
wrench in line with the nut/bolt.
4. The impact wrench drive is reversible. Depress the lower half of the power switch
to rotate clockwise (tighten) and depress the upper half of the switch to rotate
anticlockwise (undo).
When tightening wheel nuts/bolts, a torque bar with the correct torque setting
should be inserted between the impact wrench and the impact socket, otherwise
the nut/bolt might be overtightened and the wheel could be damaged.
Note! Let the motor come to a complete stop before reversing the direction of drive.
5. Release the power switch to stop the impact wrench. Unplug the product when
you have finished using it.
To Next Page
Loading...
Need help?
General