Country pro CP6502 User Manual

REV070320 CP6502
Chipper/Shredder Quick-Start Guide
1. The chipper/shredder comes with no gasoline or oil in the engine.
2. Required tools for assembly: two 13mm wrenches and pliers.
STEP 1:
Attach the support leg to the engine
mounting plate with two sets of M8x40 hex
bolts and M8 nylon lock nuts using two
13mm wrenches. Lock the support leg in
place with two lock pins. See Figure 1.
STEP 2:
Attach the wheel to the wheel axle with a
Ø12 flat washer and a Ø3x30 cotter pin.
Secure the cotter pin with the pliers.
Repeat step 2 to attach the second wheel.
See Figure 2.
STEP 3:
Attach the handle to the hopper with four
sets of M8x20 hex bolts and M8 nylon lock
nuts using two 13mm wrenches. See
Figure 3.
STEP 4:
Attach the hopper fence to the hopper with
six sets of M8x16 hex bolts and M8 nylon
lock nuts using two 13mm wrenches. See
Figure 4.
STEP 5:
Attach the tow bar to the engine mounting
plate using a lock pin. See Figure 5.
STEP 6:
Attach the bag support rod by opening it at
the hinge and sliding it into the bag rack.
Stick the flat part of the bag support rod into
the slot. See Figure 6.
Figure 1
Figure 2
Figure 4
Figure 3
STEP 7:
Attach the discharge bag to the discharge
port by inserting the bag support rod into the
rings on the discharge bag. See Figure 7.
Secure the opening of the discharge bag to
the discharge port by pulling the bag rope to
cinch the bag around the port.
Figure 7
Figure 5
Figure 6

Country pro CP6502 Specifications

General

Brand	Country pro
Model	CP6502
Category	Chippers/Shredders
Language	English

Summary

Chipper/Shredder Quick-Start Assembly

Attach Support Leg

Attach the support leg to the engine mounting plate with hex bolts and lock nuts.

Attach Wheels

Attach the wheels to the wheel axle using washers and cotter pins.

Attach Handle to Hopper

Attach the handle to the hopper using hex bolts and lock nuts.

Attach Hopper Fence

Attach the hopper fence to the hopper using hex bolts and lock nuts.

Attach Tow Bar

Attach the tow bar to the engine mounting plate using a lock pin.

Attach Bag Support Rod

Slide the bag support rod into the bag rack and secure it.

Attach Discharge Bag

Attach the discharge bag to the discharge port using the support rod.

Operation and Safety Guidelines

Pre-Start Safety and Fueling

Essential pre-start checks including adding engine oil and gasoline before operation.

Engine Controls Overview

Explanation of engine control lever, choke, and speed settings.

Starting a Cold Engine

Step-by-step guide for starting the engine from a cold state.

Restarting a Warm Engine

Instructions for restarting the engine when it is already warm.

Engine Speed Settings

Guidance on setting engine speed for shredding and idling.

Machine Operation Guidelines

Details on chipper and shredder operation limits and best practices.

Material Preparation and Safety

Instructions for using only dry wood/branches and clearing jams.