Countryman F60 - User Manual

Install the brackets on your F60 Countryman
1. First things first, we need to disconnect the negative battery cable to ensure we aren't working with any live
circuits. To get to the battery, we've got to get some stuff out of the way. Start by pealing up the rubber seal
that separates the rain drainage area from the rest of the engine compartment.
2. Once the seal is removed we can also remove the "s" shaped plastic piece, this will help with wire routing
down the line. Use the trim panel tool to pop the clip, and then the whole thing will come off.
3. Now we can access the battery box lid. It is secured by 2 8mm screws. Remove the lid and disconnect
the negative battery terminal by loosening the 10mm bolt on the clamp. Once you've disconnected the
cable, it's a good idea to secure it to the support bar to make sure it doesn't come into contact with the
terminal while you're working.

Summary

Vehicle Preparation and Safety

Disconnect Battery

Disconnect the negative battery cable and secure it to prevent accidental contact during installation.

Remove Trim for Access

Remove an "s" shaped plastic piece to facilitate wire routing and improve access to the battery area.

Grill Removal and Bracket Mounting

Remove Front Grill

Remove the front grill by first unscrewing seven T30 Torx screws located across the top of the grill.

Attach Brackets

Attach the brackets to the vehicle's v-brace using 1/4-20 x 1.25" cap screws, finger tightening initially.

Position and Tighten Brackets

Ensure brackets are level and centered, then evenly tighten bolts with a 3/16" hex wrench, avoiding overtightening.

Final Installation Steps

Reinstall Front Grill

Reinstall the front grill by ensuring clips engage, then secure it by reinserting the seven T30 Torx screws.

Countryman F60 Specifications

General

Brand	Countryman
Model	F60
Category	Automobile Accessories
Language	English