Cove DW2450 - Page 40


828019 REV B 08/2023
DW2450 and DW2450WS Service Manual
service.subzero.com 800.222.7820
Interior Component Removal and Installation
INNER RAIL REMOVAL
To remove the inner rail, first remove:
Middle rack or upper rack, as appropriate
REMOVE THE INNER RAIL
TIP: The outer rail is not replaceable.
Pull the inner rail forward.
Locate the plastic tab at the front of the roller cage
and the metal stop on the outer rail.Use a small flat-
blade screwdriver to push the tab away from the
stop, freeing the roller cage to move forward.
Pull the inner rail and roller cage out of the outer rail.
INNER RAIL INSTALLATION
After installing the inner rail, install:
Upper rack or middle rack, as appropriate
INSTALL THE INNER RAIL
TIP: The inner rail is the same for both sides of the
unit.
Insert the roller cage into the outer rail.
Push the inner rail into the roller cage and align it
properly inside the outer rail.
TIP: Make sure the tab (which limits the inner rail
travel) is to the rear of the unit.
Pull the inner rail out to verify the roller cage and
inner rail are seated.
LOWER RACK REMOVAL
REMOVE THE LOWER RACK
Open the door.
Pull the lower rack forward.
Lift the lower rack from the unit.
LOWER RACK INSTALLATION
INSERT THE LOWER RACK
Set the lower rack onto the track on the open door.
Slide the lower rack into the dishwasher.
1
1
2
3
1
1
2
3
1
2
3
1
2
40