24
TESTING SENSOR
CHANGING BATTERIES
Flood/Freeze Sensors
SEE PAGE 9 FOR REFERENCE TO:
INSTALLATION + LOCATION
Sensor
Sensor’s
Sensor
The Flood/Freeze Sensor requires one CR2450 battery. Remove the rubber feet on
the bottom of the sensor, remove the screws and the casing, and remove the old battery.
Be sure to have the + side of the battery facing towards you. After the new battery has
been replaced in the compartment, replace the casing, screws and rubber feet on the
bottom of the sensor. After replacing the batteries it is recommended that you test the
sensor to make sure it works properly.
To Next Page
Loading...