Install the product in a cool part of the room, on an even surface, out of direct sunlight and away from
humidity, dust, and dripping water.
Keep the condenser part at the rear of the product at least 4 inches away from the wall and make sure that
the installation floor is firm.
Connect power 30 minutes after installation if the device has been moved.
The tubing and the product must be connected to the cold water pipe.
(If connected to the hot water pipe, it can damage the water filter.)
After installing the product, dispense the ambient water for 3 minutes before using the cold water.
03 Maintenance
NOTE
Some of the water used for the inspection process during production may remain inside the filter.
This product is not a secondhand product, so do not worry.
Do not reuse previously used connection valves or tubes when installing the product.
To Next Page
Loading...
