This product is for 120 V~, 60 Hz.
Please connect the power plug to grounded 120 V~, 60 Hz outlet. The water filtration
device requires a power supply to operate.
Tap water must be supplied for operation.
Please check for power failure or power stoppage for other various reasons when indicators of the display unit
are turned off.
Completely drain the stored water as well as newly filtered water one more time prior to use when using the
product after an extended period of time.
After installing the product, dispense the ambient water for 3 minutes before using the cold water.
Make sure that you run the ambient water to flush the filters properly before using the cold water.
Regular filter replacement is crucial for drinking clean water. Using expired filter decreases water filtration device
performance so please replace the filter on time.
Using the water drain cap at the rear of the product, you can completely drain the water from the inside of the
cold water tank.
NOTE
Lock the tap water valve and disconnect power when not using the product for an extended period of time.
02 HOW TO USE
To Next Page
Loading...
