12
11
BUTTONS AND INDICATORS
How to use
2 sec.
If you wish to use the xed amount extraction function
You can touch the xed amount extraction button in succession to switch
between 4 options : 1 cup (250 ml), 2 cups (500 ml), POT (1 000 ml) and
Con(Continuous extraction for about 3 minutes).
∗
During extraction, press the extraction button again to stop extraction.
∗
The initial setting is set to 1 cup. If you wish to change the default setting,
press the desired extraction volume button for 2 seconds
(continuous extraction cannot be set as the default setting).
Using the cold water function
Touch the cold water button for at least 2 seconds and check if the cold water
indicator on the display lights up. To turn o the cold water function, touch
the cold water button for more than 5 seconds.
∗
After turning on the cold water function, you can drink cold water after about 3 hours.
∗
When you use the product for the rst time after the product is installed, select the cold water
mode and extract water using the continuous water extract feature until water comes out.
∗
When cooling is completed, the LED on the upper right changes in color from white to blue.
∗
According to the ambient temperature, it can take 3 to 5 hours to complete the cooling
process.
∗
To maintain performance, make sure to separate the mesh from the back of the product and
clean it every two months if possible.
Using the hot water function
Press hot water button and check that the hot water indicator is turned on.
∗
When extracting hot water, pay special attention to avoid burns.
∗
When using the hot water function once after the power is turned on, drain 1 cup of
hot water rst and it will take approximately 20 to 30 seconds and the progress will be
displayed at 0 to 100 %.
∗
If you use hot water excessively for a certain duration, its use may be limited for
5 minutes to protect the product.
To Next Page
Loading...
