Coway CHP-6200N - Installation Site Requirements; Relocation and Power Connection; Cold Water Tubing Connection; Post-Installation Flushing

18
17
HOW TO INSTALL
Maintenance
Caution!
Place for Installing Water Purier I
Avoid installing the water purier in an area with uneven surface, extreme humidity, extreme light
exposure, extreme dust exposure, and water exposure, etc.
Place for Installing Water Purier II
Keep the radiator grill at the rear of the product at least 10 cm away from the wall and make sure that the
installation oor is rm.
Relocation and installation
When moving between locations, wait at least 30 minutes after installation to connect the power.
Cold Water Tubing
Make sure to connect it to the cold water tubing
(If connected to the hot water tubing, the lters can get damaged).
After Installation
After power-up, when FL is displayed, select the ambient water button and press the extract button
to ush the lter.
- Prepare a large container to contain all the water as the ushing process takes 3 minutes.
- The process is displayed at 0 to 100% on the indicator.
Cold water is not extracted at rst use since it takes some time to ll the cold water tank.
The hot water may not be available immediately after the product is turned on.
It takes some time to set the hot water feature.
Tips
Some residual water used during post-manufacturing inspection may be present in the lter.
Do not be alarmed as it is not a used product.
Do not reuse the previously used tap water supply valve and hose when installing the purier.