PLEASE CHECK BEFORE USE
This product is for 220V - 240 V~, 50 Hz .
Please connect the power plug to grounded 220 V - 240 V~, 50 Hz outlet.
The water filtration device requires power supply to operate.
Please Check Before Use!
■
Open the tap water valve.
Tap water must be supplied for operation.
■
When indicator is turned o on
display unit
Please check for power failure or power stoppage
for other various reasons when indicators of the
display unit are turned o.
■
When using after extended period
of time
Completely drain the stored water as well as
newly ltered water one more time prior to use
when using the product after an extended period
of time.
■
After installing product
Fill up the tank and drain it completely twice or
more before use.
■
Regular lter replacement
Regular lter replacement is crucial for drinking
clean water. Using expired lter decreases water
ltration device performance so please replace
the lter on time.
■
Hot water dispensing instructions
Loosen the two screws by the door on the side to
open the door and open the red cap, connect the
dispensing hose (Continued extraction hose) to
dispense the hot water inside the water tank.
(Please be careful to not get burned when
dispensing hot or warm water.)
■
Instructions for dispensing ltered
water during power failure
Open the blue cap and connect the dispensing
hose(Continued extraction hose) to dispense
some of the ltered water. Use during power
failure and do not use to dispense hot water.
- Lock the tap water valve and disconnect power when not using the product for an
extended period of time.
Tips
To Next Page
Loading...
Need help?
General
