Some residual water used in the product inspection may be present within the lter.
Do not be alarmed as it is not a used product.
Do not reuse the tap water valve and hose used before the product installation.
Tips
Be Careful!
■
Where to install the water
ltration unit I
Install the product in a cool part of the
room, on an even surface, out of direct
sunlight and away from humidity, dust, and
dripping water.
■
After installing the water
ltration unit
Filter the water for more than 50 minutes or
ll and drain once before using the unit.
(Drain the ltered water more than twice.)
■
Cold water tubing
Make sure the unit is connected to the cold
water supply line.
(If connected to the hot water supply line,
the ltration unit may be damaged.)
■
Water ltration installation
location II
Allow a clearance of 10 cm or more behind the
product, and level the water ltration unit.
■
Relocation and installation
If the unit is relocated, do not plug in the
power cord until 30 minutes after the unit
has been installed.
HOW TO INSTALL
To Next Page
Loading...
Need help?
General
