Coway juicepresso CJP-03

Questions and Answers

X
Xavier AllenAug 16, 2025
Why does my Coway Juicer stop while operating?
- J
  Jacob BurkeAug 16, 2025
  If your Coway Juicer stops during operation, several factors could be at play. Avoid forcing too many ingredients into the juicer. If you included ingredients with hard seeds, press the REV button for 2-3 seconds, then press the ON button again. If the Squeezing Screw still doesn't rotate, stop the appliance, disassemble, clean, and reassemble it before reuse. If the power went off, ensure the product is assembled correctly. Also, if you've been running the Juicepresso for over 20 minutes, turn it off, wait, and reactivate. For continuous use, pause for 1 hour.
A
Anna ChenAug 19, 2025
Why is my Coway Juicer motor running with loud noise and shaking?
- R
  Robin ArnoldAug 19, 2025
  Loud noise and shaking in your Coway Juicer's motor can occur for a couple of reasons. Ensure all parts are assembled correctly. Noise during juicing overripe fruits and vegetables is normal; turn off the juicer and clean the receptacle. Also, using fresh ingredients is important, as overripe ones can clog the motor. If you want to use overripe ingredients, soak them in mineral water for at least 10 minutes beforehand.
S
scottjessicaAug 22, 2025
What to do if the Coway Juicer receptacle is vibrating?
- T
  Tiffany BennettAug 22, 2025
  If the receptacle of your Coway Juicer is vibrating during use, make sure you are not putting too many ingredients or liquids into the machine. If the product overheats, contact the local service centre.
A
Anthony MoyerAug 26, 2025
How to open a stuck Coway juicepresso CJP-03 drum cover?
- T
  Tyler CarterAug 26, 2025
  If the Drum cover of your Coway Juicer is too hard to open, press the REV button and open the Drum toward “OPEN”. Check the correct directions when opening the drum.
T
tfitzgeraldAug 28, 2025
How to fix a Coway Juicer that won't turn on?
- A
  amandacarpenterAug 28, 2025
  If your Coway Juicer isn't turning on, first ensure that the power cord is securely plugged into the electrical outlet. If it is, double-check that you have assembled the juicer correctly, following the instructions in the user’s manual.
J
Jamie BryantAug 31, 2025
What to do if my Coway juicepresso CJP-03 suddenly stopped working?
- M
  Michael AndersonAug 31, 2025
  If your Coway Juicer suddenly stops, there could be a few reasons. First, if you forced food into the hopper, press the “REV” button for 2 or 3 seconds, then press the “ON” button to clear any blockages. Second, if you've been using the juicer for longer than 20 minutes, turn it off and wait for 7 minutes before restarting, and avoid using it for more than 20 minutes continuously. Finally, check if the squeezing screw is rotating. If not, turn the unit off, unplug it, disassemble it, clean the hopper, drum, and screw, and then reassemble.
M
Mr. David DavisSep 3, 2025
Why is my Coway Juicer making loud noises and shaking?
- J
  jenniferparkerSep 3, 2025
  If your Coway Juicer is making loud noises and shaking, ensure it is assembled properly. It's normal for the machine to make noise when juicing over-ripe fruit, but under-ripe fruit can cause shaking. Also, make sure you are using fresh ingredients, as overripe fruits or vegetables can result in thin juice, while under-ripe fruits may clog the machine. Finally, avoid inserting too many ingredients at once; use small sections of fruits and vegetables, inserting them slowly.
T
Tony CookSep 6, 2025
Why is the juice from my Coway juicepresso CJP-03 too thick or thin?
- B
  Brian JonesSep 6, 2025
  If the juice from your Coway Juicer is too thick or thin, the rubber pad may not be assembled correctly. Ensure that you assemble the rubber pad as described in the User’s Manual.
S
Shannon JonesSep 9, 2025
Why is the drum vibrating on my Coway juicepresso CJP-03?
- U
  umillsSep 9, 2025
  Vibration during juicing with your Coway Juicer is normal if all parts are assembled properly. If the unit overheats, please contact Customer Service.
J
Joseph MartinezSep 12, 2025
How to remove the drum from the hopper of my Coway juicepresso CJP-03 Juicer?
- R
  Rachel SmithSep 12, 2025
  To remove the drum from the hopper of your Coway Juicer, ensure that the “open dot” on the hopper is aligned with the “dot” on the drum.

Summary

Safety Precautions

Children and Disabled Use Restrictions

This appliance should not be used by children or individuals with certain disabilities.

Electrical Cord and Outlet Safety

Keep the electrical cord away from heat, avoid wet handling, and use only grounded outlets.

Handling and Operation Precautions

Use caution with heavy items, do not unplug with wet hands, and avoid disassembly during operation.

Operational Safety Checks

Do not operate with a loose/damaged cord, or if the squeezing screw stops turning.

Preparations before Use

Squeezing Screw and Strainer Assembly

Assemble the squeezing screw and strainer, securing them firmly. Open counterclockwise, close clockwise.

Rubber Pad Installation

Place the rubber pad inside the designated area until it reaches the internal line for proper fit.

Assembly Instructions

Attach Drum to Main Body

Securely attach the drum to the main body of the juicer for proper operation.

Insert Squeezing Screw

Place the squeezing screw in the drum's center and push it firmly into position.

Secure Hopper to Drum

Align the hopper's 'open dot' with the drum's dot, then turn clockwise to lock it securely.

How to Use Your juícepresso

Operational Buttons Overview

Understand the function of 'ON', 'REV', and 'OFF' buttons for juicing and clearing blockages.

Juicing Process and Tips

Prepare produce by removing seeds, limit quantity, and insert slowly for optimal juicing performance.

After Use Procedures

Turn off, unplug, clean the machine immediately, and refrigerate any leftover juice.

Helpful Tips for Your juícepresso

Usage Duration Limit

Avoid using the juicer for longer than 20 minutes continuously to prevent overheating and motor failure.

Ingredient Preparation Guidance

Remove seeds/pits, use the pusher only, and insert ingredients gradually for best results.

Inoperable Machine Troubleshooting

Follow steps to clear clogs using 'REV' mode, or disassemble and clean if issues persist.

How to Disassemble and Clean

Power Off and Unplug

Ensure the juicer is turned off and unplugged from the electrical outlet before starting disassembly.

Hopper and Drum Removal

Unlock the hopper by twisting, aligning the 'open dot', then remove the drum from the base.

Component Cleaning

Clean the squeezing screw with a brush. Wash safe parts in a dishwasher or with mild detergent.

Drying Parts

Dry all disassembled parts thoroughly after cleaning; avoid using heat appliances.

Cleaning Tips

Strainer and Screw Cleaning

Clean the inside and outside of the strainer and squeezing screw with the brush and running water.

Rubber Pad Cleaning

Remove the rubber pad to thoroughly clean the strainer interior; reinsert it carefully afterwards.

Main Body Cleaning

Clean the main body with a soft, dry towel; never rinse or submerge it in water or other liquids.

Troubleshooting

Machine Not Operating

Check power connection, correct assembly, and operating time limits if the juicer fails to start.

Juice Consistency Issues

Adjust ingredient freshness, quantity, and cleaning practices for desired juice thickness or clarity.

Sudden Stoppage Solutions

Verify hopper alignment, avoid force-feeding, use REV mode, or clean the unit for sudden stops.

Noise and Shaking Problems

Ensure correct assembly and fruit type; contact support if overheating or excessive vibration occurs.