Need help?Do you have a question about the COWLEY INDUSTRIES UMB100B and is the answer not in the manual?
Warranty begins on the date stated on the receipt and is valid for 12 months.
Warranty is non-transferable without written consent from your supplier.
Warranty claims cannot be made without a purchase receipt.
Warranty applies only if the product is used as per manual and for its intended purpose.
No modifications are permitted on the product.
Warranty does not apply in cases of improper or injudicious use.
Potential shipping costs are not covered by the warranty provisions.
Repairs must be done by your supplier; third-party repairs will void the warranty.
Repairs during warranty do not extend it; repairs get a 3-month warranty if regular warranty expires.
Maintenance work described in the manual must be performed promptly.
Warranty claims must be directed to the point of purchase.
Ensure the operator has read and understood the entire manual before operating the machine.
Keep the machine area clean and free of oil/grease to prevent slips.
Avoid using the tool in damp/wet environments; ensure the work area is well-lit.
Store the machine in a closed, childproof, dry location when not in use to prevent rust.
Do not force the tool or use adapters to exceed its rated capacity; use within specifications.
Use the correct tool for the job; avoid adjustments, which void warranty and liability.
Always wear ANSI-approved safety glasses or facial protector when operating the machine.
Maintain a steady stance and avoid overreaching during operation.
Maintain tools with care, following greasing and part replacement instructions for proper working.
Check machine for damage before each use; ensure parts function properly and alignments are correct.
Do not operate the machine when tired or under the influence of alcohol, drugs, or medication.
Unpack the bender, check for damaged/missing parts, and contact retailer if necessary.
Mount the base frame to a solid, level workbench using the four holes and bolts.
Mount the handle (9) to the rotary block (10) using Ø10mm washers (8) and M10 bolts (7).
Mount the bar (18) for the material stop (16+17) to the base frame.
Mount the lever (15) to the eccentric axle (14) and insert through block (1) into the base frame.
Place the workpiece into the metal bender, utilizing the material stop (16+17).
Secure the workpiece using the block (1).
Adjust the bending stop (5) to set the desired bending angle.
Bend the workpiece to achieve the desired angle.
Safely remove the bent workpiece from the metal bender.
Use mild cleaning agents; do not remove grease from moving parts to maintain longevity.
Inspect machine for damage/wear before each use; ensure proper function of parts.
Grease guides, fingers, and moving parts every 100 working hours using EP40 Multi-grease.
Specifies the UMB100B model and its bending range from 0° to 120°.
Details the machine's weight (34kg) and dimensions (720x620x300mm).
Provides a visual parts drawing and a detailed list of components with part numbers.
Fields for user name, address, and date of commissioning for maintenance records.
Table for recording inspection dates, status (okay/not okay), and signatures.
General| Brand | COWLEY INDUSTRIES |
|---|---|
| Model | UMB100B |
| Category | Tools |
| Language | English |
To Next Page