INSTALLATION TIP: Pair the bulb using a lamp located near your Touchscreen. You can move the
bulb to any location after pairing is complete.
1. Start with the light turned off
2. Replace the old light bulb with the new Smart Bulb
3. Turn on the light
The light bulb will begin to pulse, indicating it is ready to pair with your Homelife system. You will have
3 minutes to complete the pairing process.
TROUBLESHOOTING TIP
If the bulb does not pulse immediately, or if it has timed out, you can reset it by pressing and holding
the bulb’s power button located on the side of the bulb, while installed and the light turned on. Press
the button for 20 seconds, then release. The bulb will blink five times and then begin to pulse,
indicating it is ready to pair.
3. Pair Smart Bulb with Touchscreen
1. On your Touchscreen Control Panel, press the Settings app.
2. Enter your 4-digit master keypad code.
3. From the Settings menu, select Home Devices > Lighting > Add Lights.
4. The Locating Lighting Devices screen will appear. Press Next to begin the pairing process.
Once the Smart Bulb is found by the Touchscreen, the light will become solid.
(Note: Do not press Done during the pairing process.)
5. When the “Dimmable Light” icon appears, pairing is complete. Press Done. Then
press Next to configure your Smart Bulb.
4. Configure Smart Bulb
To Next Page
Loading...