CPI InTouch Smarhub Panel

To Next Page

CPI Smarthub Panels come with the ability to customize when the system goes into

night mode (turns off display) and whether chimes / panel voices are desired

during those hours.

To adjust night time mode settings on the Smarhub Panel:

1. Tap the touchscreen to wake the panel.

2. Swipe down from the top of the screen to access the settings tray.

3. Select "Photo Frame"

4. Select the settings icon in the upper right hand corner.

5. "Nighttime Mode Start Time" is the time when the panel will start to

have a black screen until it is touched.

6. "Nighttime Mode End Time" is the time when the panel will go back to

its normal home screen.

7. "Nighttime Mode Settings" allows you to adjust whether voices and chimes

play during the Nighttime Mode.

To adjust night time mode settings on the Smarhub Panel:

1. Tap the touchscreen to wake the panel.

Need help?

Do you have a question about the CPI InTouch Smarhub Panel and is the answer not in the manual?

Summary

Adjusting Night Time Mode Settings

Wake the Panel

Tap the touchscreen to wake the panel for interaction.

Access Settings Tray

Swipe down from the top of the screen to reveal the settings tray.

Select Photo Frame Option

Choose the "Photo Frame" option from the displayed menu.

Access General Settings

Tap the settings icon located in the upper right corner.

Configure Nighttime Mode Start Time

Define the start time for the panel to enter nighttime mode (black screen).

Configure Nighttime Mode End Time

Define the end time for the panel to exit nighttime mode.

Configure Nighttime Mode Behavior

Adjust whether voices and chimes play during nighttime mode.