Frequently asked questions
Q: The PIR motion sensor alarm is switched on but does
not detect any motion
A: Maybe the system is not armed yet. Short press the
On/Off button to arm the device
(Thedevice remembers its last setting. If it was
disarmed when switched Off, it will be in disarmed
mode when it is switched On again. Pressing the On/Off
button briefly will arm the device again)
Q: The PIR does not enter pairing mode when pressing
the Pairing or Mode button
A: The device might be switched off. Try long pressing
the On/Off button to switch the unit on. Now,
enter Pairing mode by long pressing the Pairing or Mode
button
Q: The device does not switch on
A: Check the batteries. They might be empty
(16)
Q: The device signals motion when there is no motion
('false alarms")
A1: The PIR motion sensor alarm is activated by infrared
light and can also be triggered by direct sunlight. It is
advised to keep the device out of direct sunlight.
A2: Animals like dogs, birds and cats are known to
trigger PIR motion sensors as well.
Q: The remote-control indicator light is on when I press
a button but the PIR motion detector does not react to it.
A1: The signal might not penetrate walls or cover large
distances
AZ: Try opening the remote control and taking the
battery out- and back in again.
A3: The battery is running out Of power. Insert a new
battery.
Q: I have connected a Door & Window sensor, and I
cannot change the alarm sound from siren to chime
(17)
To Next Page
Loading...
