Reset to Factory settings
Follow this procedure to reset the PIR motion sensor
alarm back to the factory settings and disconnect any
remote controls and emergency sensors.
Make sure the device is switched On.
Remove one or all the batteries.
Pressthe Mode button ( and keep it pressed
throughout the next 2 event:
• Re-insert the battery
10 beeps will be heard and then another 5 beeps
very quickly
Now, release the Mode button
The factory reset is now completed.
Your PIR motion sensor alarm is reset and will resume in
Armed mode.
(14)
Technical specifications
Power: DC 5V / 3pcs * AABattery
Current: <300uA
Work
Switch off Current:<40uA
Detection Distance:<8m
Alarm sound: 125dB
Detection Angle:110 degree
Working
Detection range profile:
IMPORTANT: The Infrared detector is sensitive to a
human's vertical movement, and less sensitive to
horizontal movements, so it's best to aim the device at a
90 degrees' angle to a person's walking direction.
The PIR motion sensor alarm detects signals at a
distance up to 8 meters.
4m 6m 8m
1100
0m
2m
(15)
To Next Page
Loading...
