Page: 2/4
key– For fan speed Reverse.
POWER SWITCH – for POWER ON/OFF
6.Start the fan :
Press the fan button to run the fan at the desired .
7.Turn off the fan :
Press the OFF button .
8.Light control :
Turn the light on or off by only touching the LIGHT CONTROL button .
Keep pressing the button in excess of 0.7 second it becomes a dimmer ,
the light varies cyclically in 0.8 second .
One of the important feature of this control is AUTO-RESUME . After power
on , it allows the light return to where it was off .
GENERAL INFORMATION :
This REMOTE controller is designed to separately control your
ceiling fan speed and light brightness . The Light
ON/OFF button will control the light brightness ON/OFF .
The LED indicator on the transmitter will light when the button is pressed .
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER
1. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the OFF/STOP button for 5
seconds. The receiver will then lock in the chosen frequency. If your fan has a light it it will blink twice,
for fans without lights check operation using the transmitter
To Next Page
Loading...