Craftsman 247.889720 - User Manual

Questions and Answers

S
Susan PenaJul 30, 2025
How to troubleshoot starting issues in a Craftsman Snow Blower?
- L
  Lisa RobinsonJul 30, 2025
  If your Craftsman Snow Blower engine won't start, here's what to check: * Ensure the choke control is in the CHOKE position; if not, move it accordingly. * Verify the spark plug wire is connected; if disconnected, connect it. * Inspect the spark plug for faults; clean, adjust the gap, or replace if necessary. * Make sure the fuel tank isn't empty and contains fresh gasoline; refill if needed. * Prime the engine as instructed in the Operation Section. * Ensure the key is fully inserted into the switch. * If using the electric start, confirm the extension cord is properly connected to both the snow blower and a grounded AC outlet.
A
Ashley TorresAug 3, 2025
Why is my Craftsman Snow Blower engine running rough?
- S
  spearsmargaretAug 3, 2025
  If your Craftsman Snow Blower engine is running erratically, consider the following: * Ensure the engine isn't running on CHOKE; move the choke control to the RUN position. * Check for stale fuel and refill the tank with clean, fresh gasoline. * Inspect for water or dirt in the fuel system; drain the tank and refill with fresh fuel.
P
Pamela ThompsonAug 7, 2025
What to do if my Craftsman Snow Blower won't throw snow?
- J
  Jared FlowersAug 8, 2025
  If your Craftsman Snow Blower isn't discharging snow, here's what to do: * Immediately stop the engine and disconnect the spark plug wire. * Check the chute assembly for clogs and clean it with a clean-out tool or stick. * Look for any foreign objects lodged in the auger and remove them with a clean-out tool or stick. * Adjust the auger control cable. * If the auger belt is loose or damaged, replace it. * Replace any sheared shear pins with new ones.
D
daviskatherineAug 12, 2025
What causes power loss in a Craftsman Snow Blower?
- V
  vickithomasAug 13, 2025
  If your Craftsman Snow Blower is losing power: * Check the spark plug wire and ensure it is connected and tightened. * Inspect the gas cap vent hole for blockage from ice or snow and clear it.
A
Ann StoneAug 16, 2025
Why won't my Craftsman Snow Blower move forward?
- R
  Robert HutchinsonAug 16, 2025
  If your Craftsman Snow Blower isn't moving: * The drive cable may need adjustment. * The drive belt might be loose or damaged. * The friction wheel could be worn.
D
Dr. Heidi TaylorAug 20, 2025
How to stop excessive vibration in my Craftsman Snow Blower?
- A
  Ann SmithAug 21, 2025
  If your Craftsman Snow Blower is vibrating excessively, immediately stop the engine and disconnect the spark plug wire. Tighten all bolts and nuts. If the vibration continues, have the unit serviced.
D
Darrell RushAug 25, 2025
What to do if the chute on my Craftsman Snow Blower is hard to turn?
- J
  Joshua HammondAug 26, 2025
  If the chute on your Craftsman Snow Blower won't rotate easily, the chute may be assembled incorrectly. Disassemble the chute control and reassemble as directed in the Assembly section.