Craftsman 28928 - Troubleshooting

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed
Will not start
PROBLEM CAUSE
! Out of fuel.
2 Engine not "CHOKED" properly.
Hard to start
3 Engine flooded.
4 Bad spark plug.
5 Dirty air filter.
6 Dirty fuel filter.
7 Water in fuel.
Engine will not
turn over
to Sears service center
8 Loose or damaged wiring.
9 Carburetor out of adjustment.
10 Engine valves out of adjustment.
1 Dirty air filter.
2 Bad spark plug.
3 Weak or dead battery.
4 Dirty fuel filter.
5 Stale or dirty fuel.
6 Loose or damaged wiring.
7 Carburetor out of adjustment.
8 Engine valves out of adjustment.
CORRECTION
, , ,,.,,_ _, ,, ,
1 Fillfueltank.
2 See"TO START ENGINE" in
Operation section.
3 Wait several minutes before
attempting to start.
4 Replace spark plug.
5 Clean!replace air filter.
6 Replace fuetfilter.
7 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
8 Check all wiring.
9 See "To Adjust Carburetor" in
Service and Adjustments section.
10 Contact a Sears or other qualified
service center.
1 Clean/replace air filter.
2 Replace spark plug.
3 Recharge or replace battery.
4 Replace fuel filter.
5 Empty fuel tank and refill tank witt_
fresh, clean gasoline.
6 Check all wiring.
7 See "To Adjust Carburetor" in
Service and Adjustments section.
8 Contact a Sears or other qualified
service center.
1 Brake pedal not depressed.
2 Attachment clutch is engaged,
3 Weak or dead battery,
4 Blown fuse.
5 Corroded battery terminals.
6 Loose or damaged wiring,
7 Faulty ignition switch,
8 Faulty solenoid or starter.
9 Faulty operator presence
switch(es),
1 Depress brake pedal.
2 Disengage attachment clutch.
3 Recharge or replace battery.
4 Replace fuse.
5 Clean battery terminals.
6 Check all wiring.
7 Check/replace ignition switch.
8 Check/replace solenoid orstarter.
9 Contact a Sears or other qualified
service center.
• Mantener I_
u otros res
salpicadura
cualquier c(
que la m&qL
• Si segolpe_
e inspeccior
esario, ante
• Nunca hac_
el motor en
• Controlar Ic
hierba y lap
emente y s
per el fabric
, Nunca ileva
• No cotter ml
necesario,
tras se proc
• Nunca Iteva
apagadas, I
o interferir c
m&quina, lc
edentemenl
&rea de core
o tumbados
• Mantener Ic
vigilados po
el operador,
. Estar alerta
entre en el_
28