Craftsman 315.25031 User Manual

ASSEMBLY, OPERATING
AND PARTS LIST FOR
MODEL NUMBER 315o25031
The Model Number wi_J be found on a name plate located on
the Commutator End Coveir_ Always mention the Model Num_
bet in alt correspondence regarding the CRAFTSMAN ROUT_
ER or when ordering repair parts,
HOW TO ORDER REPA| R PARTS
All parts listed herein may be ordered through SEARS, ROE-
BUCK AND CO_ or SIMPSONSoSEARS LIMITED. When or_
dering parts by mail from the mail order house which serves
the territory in which you Ikve, setting prices will be furnished
on request or parts will be shipped at prevailing prices and
you will be billed accordingly,
WHEN ORDERING REPAIR PARTS, ALWAYS GIVE THE
FOLLOWING INFORMATION AS SHOWN IN THIS LIST:
], The PART NUMBER 3, The MODEL NUMBER--315 2503 t,
2, The PART NAME 4, The NAME of itern_Heavy Duty, Router
COAST TO COAST NAT|ON-W| DE
SERVICE FROM SEARS
FOR YOU R CRAFTSMAN H EAVY DUTY ROUTER
SEARS, ROEBUCK AND CO. and
SIMPSONS-SEARS LIMITED in
Canada back up your investmemt
with
and
MAN replacement parts,
If and when you need repairs or
service, call on us to protect your
investment in this fine piece of
SEARS, ROEBUCK AND CO.-U.S.A.
CANADA, SIMPSONS-SEARS LiMiTED

Craftsman 315.25031 Specifications

General

Brand	Craftsman
Model	315.25031
Category	Network Router
Language	English

Summary

How to Order Repair Parts

Nation-Wide Service Information

Parts List

Customer's Do's and Don'ts

Lubrication and Brush Maintenance

Repair Service and Guarantee

Operating Instructions

Assemble Motor Unit to Base

Align motor unit slot with base slot and engage motor pin in adjusting ring slot.

Remove Motor Unit from Base

Loosen locking screw and turn adjusting ring clockwise to lift motor unit from base.

Attach Sub-Base

Fasten phenolic sub-base to router base using provided screws for smooth work surface.

Install Cutters

Secure cutter in collet using nut, ensuring collet is clean for accurate results.

Adjust for Depth of Cut

Lower motor unit until cutter touches surface, then adjust ring to desired depth.

Size of Cut Recommendations

Average cut should not exceed 1/4" depth; use multiple passes in hardwoods.

Proper Care of Cutters

Use sharp cutters for best results; keep clean and avoid overheating.

Assemble Edge Guide and Contour Finger

Attach edge guide arms to router bosses and secure contour finger to edge guide.

Use of Edge Guide and Contour Finger

Used for shaping edges and making cuts parallel to work edge.

Use of Router with Dovetail Template

Butt the rounded edge of the base against the Dovetail stop for proper length.

Attachments and Accessories

Dovetail Template

For use with router and guide bushing to make dovetail joints for drawer sides and ends.

Guide Bushings and Adapter

Adapter attaches to router base; bushings guide bit against template edge for cutting.

Trammel Point Attachment

Cuts inside circles from 2" to 26" diameter and for fancy circular edge work.

Cutter Grinding Attachment

Makes keeping bits and cutters sharp and in good condition.

Formica Cutter Attachment

Holds thin sheets of Formica, phenolics for accurate cutting and edging.

Door and Jamb Butt Hinge Templates

Used for making butt hinge seats in accurately hanging doors and shutters.