Why won't my Craftsman 316.791841 engine start?
If your Craftsman Trimmer engine won't start, there are several potential causes: * The fuel tank may be empty; if so, fill it with fuel. * The primer bulb may not have been pressed enough; press it fully and slowly 10 times. * The fuel may be old; drain the gas tank and add fresh fuel. * The spark plug may be fouled; replace or clean it. * The spark arrestor may be plugged; clean or replace it.
Why does my Craftsman Trimmer engine lack power or stall when cutting?
If your Craftsman Trimmer engine lacks power or stalls when cutting, consider these possible causes: * Old fuel may be the issue; drain the gas tank and add fresh fuel. * A fouled spark plug could be the problem; replace or clean the spark plug. * The spark arrestor might be plugged; clean or replace the spark arrestor. * The carburetor may need adjustment; take the trimmer to Sears or another qualified service dealer for adjustment.
What to do if my Craftsman 316.791841 engine will not accelerate?
If your Craftsman Trimmer engine will not accelerate, it could be due to several reasons: * Old fuel: drain the gas tank and add fresh fuel. * Improper carburetor adjustment: take it to Sears or another qualified service dealer for an adjustment. * Cutting attachment bound with grass: stop the engine and clean the cutting attachment. * Dirty air filter: clean or replace the air filter. * Plugged spark arrestor: clean or replace the spark arrestor.
How to fix a Craftsman 316.791841 when the engine will not idle?
If your Craftsman Trimmer engine will not idle, check the following: * The air filter may be plugged; clean or replace the air filter. * Old fuel may be the problem; drain the gas tank and add fresh fuel. * The idle speed may be improper; adjust it according to the Idle Speed Adjustments section.
Key safety guidelines to follow before operating the trimmer.
Explanation of safety symbols and their meanings.
Advice for achieving optimal cutting performance and line longevity.
Instructions for cleaning and maintaining the air filter.
Steps to adjust the engine idle speed for proper operation.
Procedure for inspecting and adjusting valve rocker arm clearance.
Instructions for adjusting valve clearances using nuts.
General cleaning procedures for the unit.
Guidelines for storing the unit properly.
Specific instructions for preparing the unit for extended storage.
Steps for removing and replacing the spark plug.
Procedure for cleaning or replacing the spark arrestor screen.
Information on optional electric starting accessories.
To Next Page
General