SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols,.
V ......................................... Vo_t s
A............................................... Amps
Hz....................................................... Hedz
W .................................................. Walls
mtn ...................... i ............................... Minuies
............................................... Alternaltng current
_ __-= .................................................. Direct currant
no ........................................................................ NoJoad speed
_J ....................................................... Class il construction Double Insulated
Jmln ..................................... Revolulions or Strokes par minute
Z_ ................................................................. Indicates danger, warning or caution
It means attention! Your salety is Involved
SERVICE SAFETY
t If any part of Ihls saw is mFsstng or should break, bend, or fall in any way;
or should any elsclrlcal component fall to perform properly: SHUT OFF the power
switch and remove tile saw plug from the power source and have the missing.
damaged or fa+Fedparts replaced BEFORE resuming operation
2 Toot service must be performed only at a Sears Parts and Repair Center° Service
or maintenance pedormed by unqualified personnel could result in a risk el injury
3+When servicing a too!, use only' identical replacement parts, Follow Inslructtons
in the maintenance section of this manual. Use of unauthorized parts or failure to
fellow maintenanc_ instructions may craale a risk of electric shock or injury
SAFETY RULES FOR SABRE SAWS
_Keep hands away from cutting area and blade+ Keep one
hand on the handlellrigger switch and your other and on the front, top of the
saw's handle/meier housing. If both hands ere holding the saw, the
blade cannot cul them+
I Z_ CAUTION: Blades coast after saw is switched off. I
! |
t KEEP your body positioned to eilher side of the saw blade and not In direct line
with the saw blade,
2 DO NOT reach under the workplace. The blade extends under the workplace when
saw is cutting
3 DO NOT touch the blade or the workplace immediately after operation; they may
be ex!remely hot and could burn your skins
4 DO NOT cut an oversized workplace+
5. CHECK for the proper clearance under the workplace before cutting so thai lha
blade will not strike the workbench or malerial under the workplace..
9-8-06
To Next Page