Craftsman 536.773521 - Page 10

OPERATION
HOW TO USE THE
TRIMMER HEAD DRIVE LEVER
1, To engage the trimmer head, holdthe con-
trol bail against the handle. Move the
trimmer heed drive lever forward to en-
gage the trimmer head. See Figure 6. The
faster the engine runs, the faster the trim-
mar head will rotate.
2. Once the tdmmer head is rotating, push
the trimmer forward to trim.
Control Bail
Handle
Trimmer Head
Drive Lever
Figure 6
!
HOW TO USE THE
THRO'I-rLE CONTROL
1. Duting normal use, set the throttle con-
trol lever in the FAST position to run the
engine at full speed.
2. Pull the throttle control lever back to de-
crease engine speed. Push the throttle
control lever forward to increase engine
speed.
3. To stop the engine, pull the throttle con-
trol lever completely back to the STOP
position,
ThrottleControl
Lever
Figure 7
HOW TO USE
THE PRIMER BUTTON
1. Push the primer button five times, See
Figure 8 for location. Wait approximately
two seconds between each push.
NOTE: Do not usethe primer button to re-
start e warmengineafter ashortshutdown.
F_OO211M 10