Craftsman 900.37051 User Manual (English)

Questions and Answers:

K
Kenneth GrahamJul 28, 2025
Why Craftsman 900.37051 Lawn Mower does not start?
- E
  Elizabeth RogersJul 28, 2025
  Your Craftsman Lawn Mower might not start due to several reasons. First, ensure the power cord is properly plugged into both the mower and the outlet. Second, check the outlet for power by testing the breaker or fuse. Finally, if the blade doesn't rotate freely or the mower deck is clogged, unplug the power cord, turn the mower on its side, and check the blade for free rotation and clear any clogging.
D
dfarmerAug 1, 2025
What to do if Craftsman Lawn Mower cut is poor and uneven?
- K
  Kathryn McleanAug 1, 2025
  A poor and uneven cut with your Craftsman Lawn Mower can result from a worn, bent, or loose blade. Unplug the power cord. Also, check for any buildup of grass and leaves under the mower; if present, unplug the power cord and clean the underside of the mower housing. Replace the blade and tighten the blade bolt.
R
Randy DunnAug 6, 2025
What to do if Craftsman Lawn Mower stops?
- S
  Scott BrownAug 6, 2025
  If your Craftsman Lawn Mower stops, there could be a few reasons. Check your house circuit breaker or fuse. Also, unplug the power cord, turn the mower over, and clean out the deck in case foreign material is blocking blade rotation. Additionally, try walking slower, reducing the cutting width, or raising the mower cutting height.
C
Cody HowardAug 10, 2025
Why is my Craftsman Lawn Mower having poor performance?
- B
  Brian SmithAug 10, 2025
  If your Craftsman Lawn Mower is showing poor performance, it might be because the grass is too high or thick; in this case, raise the mower cutting height to cut only 1/3 of the grass length. You may also need to walk at a slower pace, reduce the cutting width, or unplug the power cord to check the deck for clogging and the blade for sharpness.
L
Lori AllenAug 15, 2025
What causes excessive vibration in a Craftsman 900.37051?
- J
  jasonclarkAug 15, 2025
  Excessive vibration in your Craftsman Lawn Mower can be caused by a worn, bent, unbalanced, or loose blade. Unplug the power cord, replace the blade and tighten the blade bolt. A bent motor motorshaft can also cause this, in which case you should contact an authorized service center.
M
Mr. Patrick Greene VAug 18, 2025
Why is my Craftsman 900.37051 hard to push?
- K
  Kenneth Juarez MDAug 18, 2025
  If your Craftsman Lawn Mower is hard to push, it may be because the grass is too high or the wheel height is too low. Try raising the cutting height.
J
John LeeAug 23, 2025
What to do if Craftsman Lawn Mower Does Not Stop when Operator Presence Control Switch is Released?
- K
  Katie JacksonAug 23, 2025
  If your Craftsman Lawn Mower does not stop when the Operator Presence Control Switch is released, it indicates that the operator presence control switch is damaged. Replace the operator presence control switch.