EasyManua.ls Logo

Craftsman 917.270921 - Page 32

Craftsman 917.270921
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PROBLEM
TROUBLESHOOTING CHART
CAUSE
Poor grass
discharge
Headlight(s) not
! working
(if so equipped)
Battery wUt not
charge
Loss of drive
Engine "backfires':
when turning
engine
"OFF"
Engine speed too slow.
Travel speed too fast.
Wet grass.
* Mower deck not level.
Low/uneven tire air pressure.
Worn, bent or loose blade.
Buildup of grass, leaves and
trash under mower.
Mower drive belt worn.
Blades improperly installed.
Improper blades used.
Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
Switch is "OFF".
Bulb(s) burned out.
Faulty light switch.
Loose or damaged wiring.
Blown fuse.
Bad battery ceil(s).
Poor cable connections.
Faulty regulator
(if so equipped).
Faulty alternator.
Freewheel control in
=disengaged" position.
Motion drive belt worn,
damaged, or broken.
Air trapped in transmission
during shipment or
servicing.
Engine throttle control not
set at =SLOW"
position for 30 seconds
stopping engine.
CORRECTION
Place throttle control in
"FAST" position.
Shift to slower speed.
Allow grass to dry before
mowing.
Level mower deck.
Check tires for proper air
pressure.
Replace/sharpen blade.
Tighten blade bolt.
Clean underside of mower
housing.
Replace mower drive belt.
Reinstall blades sharp edge
down.
Replace with blades listed in
this manual.
Clean around mandrels to
open vent holes.
-rum switch "ON'.
Replace bulb(s).
Check/replace light switch.
Check wiring and connec
tions,
Replace fuse.
Replace battery.
Check/clean all connections.
Replace regulator,
Replace alternator.
Place freewheel control in
=engaged" position.
Replace motion drive belt.
Purge transmission.
Move throttle control to
=SLOW" position and allow
to idle for 30 seconds before
stopping engine.
32

Table of Contents

Related product manuals