EasyManua.ls Logo

Craftsman 917.273421 - Mower Blades Will Not Rotate; Poor Grass Discharge; Battery Will Not Charge

Craftsman 917.273421
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING CHART
CAUSE CORRECTION
PROBLEM
Poorgrassc_scharge
cont.)
Headlight(s)notworking
(ifsoequipped)
Battery will not charge
Loss of drwe
Engine"backfirewhen
turning engine "OFF"
i.
Mower deck not level.
Low/uneven tire air pressure.
Worn. bent or loose blade,
Buildupof grass, leaves and trash
under mower.
Mower drive belt worn.
Blades improperly installed.
Improperblades used.
Clngged mower deck vent holes
from bui|dup of
grass, leaves, and trash around
mandrels.
Switch is "OFF".
Bulb(s) burned out.
Faulty lightswitch.
Loose or damaged widng.
! BLOWNfuse.
Bad battery cell(s).
Poor cable connections.
Faulty regulator(if so equipped).
Faulty alternator.
Freewhe_ contr_ in%isangags_"
position.
= MotiOndrive belt worn, damaged or
broken.
Air trapped in transmissiondudng
shipment
or servicing.
Engine throttlecontrolnot set at
"SLOW" position for 30 seconds
before stoppingengine.
Level m_owerdeck.
Check tiresfor proper air pressure.
Replace/sharpen blade. "Sghten
blade bolt.
Clean underside ofmower housing.
i Replace mower drive belt.
I " Reinstall blades sharp edge down.
Replace with blades listedin this
manual,
Clean around mandrels to open vent
holes.
Turn switch"ON".
, Replace bulb(s).
Check/replace light switch.
Check widng andconnections.
Replace fuse.
Replace battery.
Check/clean allconnections.
Replace regulator.
Replace alternator.
Place freewheel controlin
"engaged" position.
Replace mo_on drive belt.
Purgetransmission.
Move throttlecontrolto =SLOW"
positionand allow to idle for30 sec-
onds before stopping engine.
34

Related product manuals