Do you have a question about the Craftsman 917.275660 and is the answer not in the manual?
Engine Type | 4-Cycle |
---|---|
Engine | Briggs & Stratton |
Engine Power | 6.75 HP |
Engine Displacement | 190cc |
Cutting Width | 21 inches |
Deck Material | Steel |
Mulching Capability | Yes |
Bagging Capability | Yes |
Side Discharge | Yes |
Wheel Size (Front) | 8 inches |
Drive Type | Rear Wheel Drive |
Starting System | Pull Start |
Details warranty coverage and exclusions for riding equipment.
Details warranty coverage for the tractor's battery.
Safety instructions for general tractor operation.
Crucial warnings regarding starting, towing, engine exhaust, and battery.
Guidelines for safe operation on slopes to prevent tip-overs.
Safety precautions concerning children in the mowing area.
Safety instructions for towing and safe handling of gasoline.
Safety practices for maintenance, safety devices, and general operation.
A pre-operation checklist to ensure proper setup and readiness.
Explanation of the safety alert symbol and hazard levels.
Familiarization with tractor controls and their functions.
Detailed explanation of each tractor control's purpose and operation.
How to control tractor movement using the motion control lever.
Instructions for adjusting the mower deck's cutting height.
Steps to engage and operate the mower blades.
Explanation and usage of the Reverse Operation System.
Safety and operational guidelines for mowing on hills.
Pre-start checks, including engine oil level.
Instructions for safely adding fuel to the tractor's tank.
Procedures for starting the engine in warm and cold weather.
Procedure to purge air from the transmission for proper operation.
Advice for optimal mowing performance and grass cutting.
A schedule outlining maintenance tasks based on operating hours.
Daily checks to perform before operating the tractor.
Step-by-step guide for changing the engine oil.
Safety precautions before performing any service or adjustments.
Procedure for adjusting the tractor's brake system.
Instructions for adjusting the carburetor for optimal performance.
Causes and corrections for tractor not starting or hard to start.
Causes and corrections for engine not turning over, clicking, loss of power, or vibration.
Causes and corrections for engine dying, poor cut, or blades not rotating.