To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 917.364250 and is the answer not in the manual?
General| Model Number | 917.364250 |
|---|---|
| Category | Lawn Mower |
| Type | Walk-Behind |
| Engine | Briggs & Stratton |
| Engine Type | 4-Cycle |
| Cutting Width | 21 inches |
| Cutting Positions | 6 |
| Drive Type | Self-Propelled |
| Drive System | Rear-Wheel Drive |
| Speed Settings | Variable |
| Oil Capacity | 20 oz |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Power Source | Gas |
| Cutting Height | 1.25 to 3.75 inches |
| Wheel Size | 8 inches (front) |
Specific safety warnings and recommendations concerning children.
Information on accessories for enhancing mower performance.
Accessories related to maintaining the lawn mower.
Steps for unpacking the mower and setting up the handle.
Steps for assembling the grass catcher attachment.
Guide for installing the starter rope on equipped models.
Guidance on converting the mower for different operations.
Familiarization with mower controls, symbols, and CPSC safety compliance.
Engine speed, zone control, drive control, cutting height, starting, stopping, and general mowing tips.
Steps for converting the mower for mulching, bagging, or discharging.
Procedures for side discharging and emptying the grass catcher.
Instructions on adding oil and gasoline before starting the engine.
A schedule detailing routine maintenance tasks, checks before use, and recommendations.
Instructions for removing, replacing, and sharpening the mower blade.
Engine oil, air filter cleaning, spark plug, and muffler maintenance.
Procedures for cleaning the mower housing and under the drive cover.
Instructions for adjusting cutting height and handle positions.
Steps for removing and replacing the drive belt.
Information on the function and replacement of the rear deflector.
Steps for storing the mower, handle, and fuel system.
Causes and corrections for the mower failing to start.
Troubleshooting for power loss, poor cut, vibration, drive speed, and starting rope.
